Barely Significant

Excerpts

27,100 sentences · 1 filter applied

2 -c can be seen, in other conditions the same case, the extraction rate of goose oil with the increase in the material-liquid ratio showed a trend of first increase and then decline to the material-liquid ratio of 1:5 when the beginning of the decline may be due to the increase in the amount of solvent, the extraction rate of the goose oil, which is due to an increase in the solvent, which is conducive to the exudation of fats and oils, and at the same time increase the contact area of the goose fat with the solvent.
highly significantqualifiedgold
As is shown in Table 3 , the analysis of variance showed that this model was significant ( p < 0.01),indicating that the regression model as a whole was highly significant, and the model misfit term was not significant; R2 = 0.9435, indicating that the model fit was good, indicating that this experiment has a certain degree of feasibility.
highly significantqualifiedgold
Correlation analyses using comprehensive gene signatures (see Table S2) demonstrated a highly significant negative correlation of the differentiation score with the category “Neural crest cell differentiation”, indicating that the high differentiation potential of NC progenitors diminishes along the differentiation axis (Fig. 3 F, left).
Results of stress analysis Vertebral stress analysis At different forward flexion angles, the stress of L1-S1 in both TLK patients and healthy subjects showed an increasing trend, and the S1 stress in TLK patients was significantly higher than that in healthy subjects at 60 degrees and 90 degrees of forward flexion, which were 45.0 and 41.0 MPa, respectively, and 2.06 and 2.8 times higher than that of the healthy subjects (Fig. 5 ).
Comparing the average water absorption rates of Groups B, C, D, and E, the overall average water absorption rate showed an increasing trend with the number of wet and dry cycles, and the average water absorption rate of the mining sandstone with the number of wet and dry cycles in Table 1 was fitted to the relationship Equation (0 ≤ n ≤ 10) as shown in Fig. 4 : 4 \documentclass[12pt]{minimal} \usepackage{amsmath} \usepackage{wasysym}