Excerpts

Moreover, as shown in curve (a) in Figure 14 , as the immersion time was prolonged, the short-circuit current density showed a trend of first increasing and then decreasing, reaching the maximum at 30 min.

Because the magnetic fields strength generated by the four composite rails in the launch space cancel each other out, the magnetic field strength in the middle of the launch area is weak, and the magnetic field in the middle area of the launch shows a decreasing trend as the thickness of the steel layer increases.

Whether the amplicons of one taxa will be suppressed over those of others and whether a definite trend will be deducible from these effects, such as that predisposing microorganisms with certain phenotypic features to be affected more than those with others, are some of the questions that this study has attempted to answer.

The removal rate of Mg from the samples showed an increasing trend as the addition dosage increased.

At 7 days after implantation, iNOS positive cells in each group showed a decreasing trend, while CD163 positive cells revealed an increasing tendency ( Figure 8 C,D) compared with those at 3 days after implantation ( Figure 8 A,B).

Consequently, the strengths of the alloys exhibit an increasing trend with increasing rolling reduction, whereas the EL of the alloys shows a decreasing trend.

Therefore, the EL of hot rolled Mg-Sn alloys shows a decreasing trend with increasing rolling reduction.

On the contrary, because of the excellent photocatalytic effect of TiO 2 , the concentration curve of TiO 2 /CF and TiO 2 @CB/CF show a clear trend of declining with irradiation time, and the photocatalytic degradation ability of the TiO 2 /CF (~48%) is worse than that of the TiO 2 @CB/CF (~57%) after 120 min illumination.

The reason for this is that cotton fabric and CB/CF have no photocatalytic properties, and the concentration of MB had an increasing trend with the evaporation of water.

When temperature and residence time increase, the production of aromatics also shows an increasing trend.

Similarly, the tensile strength of the composites was unaffected by weathering, although strain at yield and break showed a decreasing trend due to the ductile behavior of the composites.

Hardness has shown an increasing trend because of SZ grain refinement, the existence of Mg 17 Al 12 particles, and solid solution strengthening in the SZ [ 17 ].

As illustrated in Figure 5 , the damping coefficient c 1 decreases gradually with the increase of the loading amplitude, while the damping coefficient c 2 shows an increasing trend.

(2) In studying the effects of different silica fume dosages on the compressive strength, thermal conductivity, and pore structure parameters of FAFC at 5% of hydrogen peroxide, the dry density of FAFC showed a decreasing trend with the increase in silica fume dosage, and the remaining indexes all peaked.

It can be observed from Figure 16 that with the increase in the silica fume admixture, the FAFC porosity showed a trend of first decreasing and then increasing, and the FAFC porosity kept falling when the silica fume admixture rose from 0 to 4%.

With the extension of the maintenance age, the compressive strength of FAFC samples with different amounts of silica fume admixture all showed an increasing trend.

This behavior indicates that C-S-H polymerization has a decreasing trend throughout the process, being particularly small after the 2SP, in agreement with the C/S ratio.

This suggests that all of the elements have a role and are likely to be significant.

The release curve profiles ( Figure 6 a–c) and the correlation equations ( Table S4 ) describing those curves showed fairly significant sorption of peptides 1 – 3 by the fibrous carrier on which they were deposited.

The DC-bias% shows an increasing trend as the phosphating concentration is increased from 0.4 to 1.6 wt.%.

Despite the wide range of E 0 values, the present results highlighted an increasing trend in E 0 values as a function of indenter diameter up to 6 mm.

Increasing the water content leads to decreasing SFRC FS, leading to a decreasing trend.

With the change in CTAB, GA, and SDS contents, the absorption peak at 260 nm and the absorbance of dispersion liquid showed an increasing trend.

With prolonged aging time, the strength of the alloy shows an increasing trend at times longer than 5 to 8 h, and then the strength of the alloy decreases again.

Although the electrical properties significantly changed with respect to the In concentration, an apparent trend depending on the In concentration was not observed in the structural properties of the IZO film.