Excerpts

An interesting trend was observed in pile A1—the highest temperatures, even >70 °C, were found at the end furthest from the fan ( Supplementary material section 47.5 m Figures S4d and S5c,d ) from where the heat spread towards the front of the pile.

As these microorganisms can adhere to titanium surfaces, they may be significant in the colonization of dental implants and subsequent infections [ 70 ].

The fact that the P -values were less than 0.05 indicated that the regression effects of models Y 1 and Y 2 were highly significant.

The soil conductivity above this position showed an increasing trend with rising capillary water.

With increasing corrosion time, R cp showed a trend of first decreasing and then increasing.

From Figure 3 for the results for all wood images, we can see a clear trend that observers found higher elevation prints more natural than flatter ones.

Figure 4 shows that when the vacuum degree is higher than 60 kPa, as the vacuum degree decreases (the preparation pressure increases), the specific gravity of K 2 CO 3 in the composite material shows a decreasing trend.

With the increase in the opening times, the amount of residual char from BF pyrolysis showed a decreasing trend. 3.3.

In each case, the flexural modulus is higher for the filled samples compared to the base PLA (which is typical for filled composites), with an increasing trend with more filling.

If the p -value is less than 0.01, the difference is highly significant.

The IS value also showed an increasing trend as the particle size rises.

Principal components have a decreasing trend in variance, i.e., the first principal component has the maximum variance.

A decreasing trend in density was observed due to the incorporation of RW.

The volume wear rate of as-sprayed coatings had a decreasing trend with an increase in aluminium content from 0.5 to 1.5 under dry sliding conditions.

It can be seen from the analysis of variance in Table 3 that the p -value of the liquid flow rate, CPCM thickness and the cross-sectional area of the pipe is less than 0.0001, indicating that the impact on T max of batteries is highly significant.

The p -value of the model is also less than 0.0001, indicating that this model is extremely significant, so this model can be used to accurately predict the changes in T max of the battery module.

Introduction In today’s food packaging field, there is an increasing trend to replace non-degradable plastic packaging materials using annually renewable natural biopolymers to solve the problems of environmental pollution and resource depletion caused by the use of synthetic plastics [ 1 , 2 ].

All results of G*/sin δ presented an increasing trend with the addition of CRM, which is recognized to be similar to that of the original G*/sin δ as shown in Figure 7 .

G*sin δ value for CRM binders was observed to have a decreasing trend with increasing CRM content.

%rec results showed a trend almost similar to J nr ; the addition of CRM positively affects the rutting property, and %rec increased with the addition of TPU into the CRM binder.

At the age of 7 d, the compressive strength increased with the increase of Ca(OH) 2 dosing; while at the age of 28 d, the compressive strength showed a trend of increasing and then decreasing with the increase of Ca(OH) 2 dosing.

With the increase in the sample width, the T 1 shows a decreasing trend, indicating that the increase in the crack initiation energy has an inverse correlation with the increase in the sample width.

With the decrease in IOTs admixture, the overall 28-day compressive strength of concrete showed an increasing trend.

Flexural Strength—Fiber Volume-Mixing Ratio Curve As can be seen from Figure 3 , with the increase in the volume-doping ratio of various fibers, the flexural strength of PUC at each temperature showed a trend of first increasing and then decreasing.

Accordingly, the grain size presents a decreasing trend with the substitution of Sr and the increasing Zr content of x from 0.1 to 0.4.