Excerpts

[ 20 ] found that the effects of sheet thickness, wall angle, step size, and the interaction between the sheet thickness and wall angle are extremely significant for profile accuracy.

p -values between 0.05 and 0.1 were rated as a statistical trend. 3.

The stretched samples exhibited a decreasing trend in tensile properties as compared to the as-received alloy.

For the “grey” EPS from [ 42 ], the radiation contribution was zero and the matrix contribution revealed an increasing trend, from 15.3% to 20.7% (at the expense of the air contribution), with thickness increasing from 0.01 to 0.10 m.

The results of both the docking and DFT studies have been analyzed with respect to the mechanistic interaction pattern that may be significant in the context of the interpretation of the obtained binding energy values.

The increase in mechanical properties of mortar containing GSA with a decreasing trend in hardened density was determined.

However, the capacity of the pyrolyzed CNC electrode ( Figure 8 a) showed an increasing trend, and remained stable during 300 cycles, while that of the CNC–SnO 2 NF800 electrode decreased rapidly during the first 100 cycles and showed a capacity of 284 mA h g −1 , similar to that of the pyrolyzed CNC electrode after 300 cycles (276 mA h g −1 ).

Therefore, the observed difference is quite significant. 3.3.

reported that the decrease in the crystal size was highly significant even at the lower Mg percentage, and crystal size decreases with the increase in Mg concentration up to 35 atomic percentage in respect of the total metal ions.

With the increase of the graphene doping amount, the bulk density of SiC ceramics showed a trend of gradual decrease.

The room temperature magnetic properties exhibited that Co doped GNMSs are ferromagnetic in nature and an increasing trend in magnetism was observed with increasing Co contents.

A particular source of variation may be significant if the calculated F value at a certain confidence level is greater than the tabulated F value at the same confidence level.

An increasing trend in the size of the deformation zone by up to four times its original pore size is reported at a higher feed rate and lower cutting speed [ 18 ].

However, many other parameters, like temperature, pH, potential difference and impurities are highly significant.

The elongation at break, which is an indicator of material flexibility, followed a decreasing trend with increasing loads of CNF.

With the developments in digital image acquisition and image processing techniques, the quantification of structural features, 3D model rebuilding together with the finite element (FE) mesh generation is considered to be a significant trend of current Micro-CT research.

In C75 concrete there is also a pronounced initial evolution, but with an increasing trend until 72 h and with much higher values, at least 45% at 24 h and 80% at 72 h, comparatively with the other concretes.

After the coupling of 90 days, elastic modulus of the bars showed a decreasing trend with the increase of the cyclic loading.

For the three cement compositions including both ACC and vaterite, the results show a clear trend: higher initial vaterite concentration leads to faster growth rates and a faster recrystallization process.

Nevertheless, although a clear trend cannot be defined, it seems that there is an average increase in the relative intensity of the carbonyl band in all the bio-composite systems.

Permeation, which describes the net effect of diffusion and sorption, in general, presented a decreasing trend with the increasing content of fibers, confirming the prevailing effect of diffusivity.

It is rather difficult to find a clear trend for the influence of fiber type, length or quantity in the composition without a clear correlation. 4.1.2.

Additionally, the heat flow values of saturates and saturates/EG/MH show an increasing trend on the whole, but the heat flow values of saturates are higher than those of saturates/EG/MH.

Therefore, one of the composite’s main beneficial characteristics (high strength) has a minor significance in the case of axially compressed reinforced concrete elements. 5.

However, as the cooling rate increased, the mechanical properties of the alloy showed a trend of first increasing and then decreasing, which had a mathematical extreme value.