Excerpts

The strength of a soil decreases after erosion, and the magnitude of the soil strength decrease after particle erosion was quite significant.

On the other hand, the effect of parameters such as NPs concentration and presence of citrate vary depending on the specific combination of plasmonic metal and excitation wavelength, lacking a definite trend.

In the TG curve, there is a clear trend of decreasing mass between the two peaks, with a mass loss of 19.77%.

Some samples showed a trend for a higher Young’s modulus in wet conditions.

The stress-strain curves showed an increasing trend of slope with the increasing content of FR-DOMt, especially when the elongation was lower than 500% ( Figure 6 a).

For coating 5 and coating 6, their friction coefficient presents an increasing trend with sliding time and fluctuates greatly at the later period of sliding friction test.

The interaction of tool material and feed strategy shows that the generated force has a decreasing trend for HSS-Ti, HSS-Co, and HSS-Mo.

Grain growth is almost insignificant during this time, however, after 8 h a noticeable increase in grain width is measured.

observed a decreasing trend in the relative density of their SLM NiTi samples with an increase in the exposure time (point distance divided by laser scanning speed) [ 16 ].

This elongation shows a decreasing trend as the angles increase.

On the other hand, in the asymmetric derivatives with fixed chain length in one of the substituents (m = 12), the increasing asymmetry does not show a clear trend, and the BF 4 -8,12 (10) shows the best LC properties.

The adsorption of nitrogen in Cd 2+ adsorbed composites (RC, RCCA-5, and RCNC-5) show an increasing trend as pressure increases, although not significantly by adsorption of Cd 2+ .

As the graph shows, with an increase in frequency, the nano Ni 0.6 Zn (0.4−x) Co x Fe 2 O 4 system of the tan delta value exhibits an overall trend of increasing after first decreasing.

More specifically, the results depicted in Figure 4 show that the maximum curcumin uptake is exhibited by β-TCP, and there is a decreasing trend to the loading capacity as the HA component increases.

At earlier ages, lower-density aerated slurries exhibit a minor rise in UPV for more than 10 h while the higher-density slurry exhibits a clear trend towards UPV increase as soon as 1 h after mixing.

This is a positive trend, indicating that lowering the density of the slurry via aeration would actually improve its barrier qualities for protecting the building interior as well as the natural insulation against weathering effects.

The microhardness, shear strength, and compressive strength of the composites had a decreasing trend with graphene contents of 0.5–1.5 wt %.

With the increase in reaction temperature, the value of I D /I G basically presented a decreasing trend, indicating that the structural order in samples was partially restored.

If TiO 2 was not able to develop pozzolanic or hydraulic activity, a decreasing trend would have been detected for cement pastes added with increasing TiO 2 content.

In Case II, an increasing trend can be observed.

It is also worth noting that, at a low frequency band, i.e., 3–9 GHz, a decreasing trend can apparently be found for the real part of the permittivity.

Even at a Reynolds number much lower than 1, this efficiency remains quite significant (≈0.3) while the theoretical behavior in Stokes flow is particles avoiding each other at their initial relative positions, which leads to zero efficiency.

Since immunotherapies are becoming an important trend to treat non-communicable diseases, the RAGEp/PSiP vaccine will serve as a useful model in the development of chronic conditions such as Alzheimer’s disease and cancer.

Once NPs, PVDF and DBP were blended, the ε c was found to show a decreasing trend with increasing the testing frequency.

It is interesting to note that the O-Ce bond length initially showed an increasing trend, which became nearly constant for CeZr-2, CeZr-3, CeZr-4, and CeZr-6. 3.2.