Excerpts

Figure 9 shows a positive correlation between q u and curing period of RMLS that there is an increasing trend of q u with the increase of curing age when D R is fixed.

With the growing hydration degree, the bulk modulus, shear modulus, and elastic modulus of the cement paste all show an increasing trend, and the differences between these parameters also increase gradually.

However, no exact statement about a clear trend of the PU-RAP addition is possible.

Initially, it seems as if there would be a deterioration of the deformation resistance with increasing PU-RAP, because the bars of the variants RAP25, RAP50 and RAP75 show a positive trend.

The void content shows a decreasing trend.

An interesting trend was observed in pile A1—the highest temperatures, even >70 °C, were found at the end furthest from the fan ( Supplementary material section 47.5 m Figures S4d and S5c,d ) from where the heat spread towards the front of the pile.

As these microorganisms can adhere to titanium surfaces, they may be significant in the colonization of dental implants and subsequent infections [ 70 ].

The fact that the P -values were less than 0.05 indicated that the regression effects of models Y 1 and Y 2 were highly significant.

The soil conductivity above this position showed an increasing trend with rising capillary water.

With increasing corrosion time, R cp showed a trend of first decreasing and then increasing.

(4) Water–cement ratio As shown in Figure 4 and Figure 5 , the slump and slump expansion of concrete show an increasing trend as the water–cement ratio increases.

As the water–cement ratio increases, the compressive strengths show a decreasing trend.

From Figure 3 for the results for all wood images, we can see a clear trend that observers found higher elevation prints more natural than flatter ones.

Figure 4 shows that when the vacuum degree is higher than 60 kPa, as the vacuum degree decreases (the preparation pressure increases), the specific gravity of K 2 CO 3 in the composite material shows a decreasing trend.

With the increase in the opening times, the amount of residual char from BF pyrolysis showed a decreasing trend. 3.3.

In each case, the flexural modulus is higher for the filled samples compared to the base PLA (which is typical for filled composites), with an increasing trend with more filling.

The swelling index of 2.0 phr MPP-filled NR latex films was comparable with the control sample, while ZnO NP-filled NR latex films displayed a decreasing trend in the swelling index when the loading increased.

For a feed rate of 0.16 mm/tooth, there was a slight decrease in RSm to 0.027 mm, followed by an increasing trend.

The parameter maximum peak height of the roughness profile Rp in the feed rate range 0.02 ÷ 0.06 mm/tooth ( Figure 9 a–c), showed a decreasing trend, from a maximum value of 0.818 μm to 0.552 μm.

Complex INPs The production of particles with an optimal ratio of magnetic properties and antibacterial activity has seen an increasing trend in recent years.

The surface roughness value of the vertical-plane showed a trend of first increasing and then decreasing with an increasing current density, and the roughness was the largest machined at 10 Acm −2 , which was 42 μm.

For the four different thicknesses, the peak stress of the wave-absorptive metal plate as a whole maintained a decreasing trend with an increase in the aperture size.

We believe that this study may be significant for investigations on the topological physics of Weyl semimetals.

Since the probability p was lower than 0.05 for all the sample typologies reported in Table 2 , the differences between the samples welded with different parameters were considered highly significant.

Therefore, the logarithmic numbers of cycles to failure at S max = 0.75 were analysed statistically for each concrete with the purpose of evaluating possibly significant differences between both batches.