Excerpts

In addition, in the literature, a clear trend was not found with the increase in the number of recycling loops.

As illustrated in Figure 1 b, with the increase of sol ratio, the compressive strength showed an increasing and then a decreasing trend at 7 d and 28 d.

Moreover, as shown in curve (a) in Figure 14 , as the immersion time was prolonged, the short-circuit current density showed a trend of first increasing and then decreasing, reaching the maximum at 30 min.

Because the magnetic fields strength generated by the four composite rails in the launch space cancel each other out, the magnetic field strength in the middle of the launch area is weak, and the magnetic field in the middle area of the launch shows a decreasing trend as the thickness of the steel layer increases.

S5 with EAC applied in the middle-lower layers has the lowest tensile strain at the bottom of the asphalt layer and lowest tensile stress at the bottom of the base, decreasing by 11.81% and 1.54% compared to S0, respectively; however, S4 and S6 with EAC applied have an increasing trend in the upper layer.

It can be observed from the corrosion current density (i corr ) values that the corrosion resistance has shown an increasing trend when Sn content increased from 1 wt.% to 5 wt.% in Mg-Sn alloys.

Additionally, the tensile strength change curve of the QPFP showed a trend in linear function.

In addition, the line from the point to the origin in Figure 5 d shows an increasing trend, indicating that the misorientation angle increases along the AB line within P1.

An increasing trend of a fraction of HABs and TBs from RS towards AS in both the two phases is observed in Figure 7 .

Obviously, the strain is dominant as evidence of a decreasing trend of LABs from region a to region c.

The EQE improvement is quite significant after introducing the microgrooves at the heterojunction interface in sample S2, which is estimated to be about 22% at 610 nm.

Before the G point of the stress–strain curve, although the bearing capacity of the rock sample decreases, the total energy still shows an increasing trend due to strong lateral constraints.

However, it indicates a decreasing trend in the R value with a positive increase in rake angle α (see Figure 7 D).

From the plot, it is very difficult to determine a clear trend.

The G* (complex modulus) of asphalt added with warming agent shows an increasing trend, the phase angle δ shows a decreasing trend, and the improved rutting factor G*/(sinδ) increases.

The degree of inversion of the mechanically activated powders did not show a clear trend with temperature.

The difference between coordinates is quite significant.

Despite the wide range of E 0 values, the present results highlighted an increasing trend in E 0 values as a function of indenter diameter up to 6 mm.

With prolonged aging time, the strength of the alloy shows an increasing trend at times longer than 5 to 8 h, and then the strength of the alloy decreases again.

In reality, results also show that although the influence is not so relevant, a small trend seems to suggest that the lower the height, the lower the fatigue performance.

However, the strengthening effect of micro- or sub-microscale twin lamellae was not obvious, while that of nanoscale twin lamellae was quite significant [ 21 ].

It can be seen that the specific heat capacity of the composite PCMs showed a trend of increasing first and then decreasing, reaching the maximum at around 9 wt.% EG. 3.3.

The test results showed that with increases in temperature, the uniaxial compressive strength, shear strength, and elastic modulus of concrete all presented a decreasing trend, while the peak strain had an increasing trend.

Therefore, the absorption peak in our measured transient absorption spectrum showed a trend of blue shift first and then red shift with the increase in pressure [ 56 , 57 ].

The P 2 O 5 content of the C 2 S particles showed a decreasing trend from the edge toward the center.