The free swell index emerges as a highly significant predictor (β = −2.4083, p = 0.002), confirming its importance as a mediating variable.
Excerpts
At 3 months, PPD changes were −1.46 mm for the test quadrants and −1.25 mm coming very close to statistical significance (p = 0.002) with a further improvement to −1.74 mm in test quadrants and −1.55 mm in the control quadrants at 12 months with p values still not significant.
In contrast, samples corresponding to the F-FAOM global group showed almost twice the proteoglycans expression found in AFAS and n-FAOM, although differences with these two global groups were only marginally significant ( p = 0.0020 vs.
For the response variable Y 1 (Flexural Strength), the nano-silicate factor ( X 1 ) was found to be highly significant ( p = 0.00279), while the other factors showed no statistically significant effects.
Post hoc comparisons showed that the 2.2% decrease with five embedded fibers was not statistically significant compared to the unembedded baseline ( p = 0.32), whereas the 12.4% decrease with 10 embedded fibers was highly significant ( p = 0.003).
For D 3,2 , the linear ZnO term was highly significant (β 2 = −19.7 nm, p = 0.004), indicating progressively smaller droplets at higher ZnO levels, while the quadratic linseed oil term (β 11 = +15.3 nm, p = 0.012) revealed a curvature that penalised very high oil fractions.
Statistical differences were specified as follows: Significant for p -values less than 0.05 (* p ≤ 0.05) and highly significant if p -values were less than 0.01 (** p ≤ 0.01). 3.
The difference between fracture load, flexural strength, and deflection between the two groups was statistically highly significant ( p < 0.01).
Thereby, data were marked as significant if p -values were less than 0.05 (* p ≤ 0.05) and highly significant if p -values were less than 0.01 (** p ≤ 0.01) or less than 0.001 (*** p ≤ 0.001) and graphed as mean ± standard deviation. 3.
The Bonferroni test confirmed highly significant effects ( p < 0.01) between one and two, as well as two and three layers for FE.
A highly significant ( p = 0.010, PC = 0.135) correlation between S. sanguinis adhesion and R z was identified.
Penetration among root end filling materials showed a statistically highly significant difference in vertical depth of penetration among sealer with F = 248.03 and p value = 0.01.
The Osteoset ® group showed the highest value of F 1+2 activation; at 274.3 pmol/L, it was highly significant ( p < 0.01; **), compared to pure blood activation and outside the assay’s reference range.
Significance levels were set to significant * p ≤ 0.05 and highly significant ** p ≤ 0.01.
Notably, RD demonstrates a highly significant influence ( p < 0.01).
Temperature exhibited an extremely significant effect (F = 60.22, p < 0.01), while reaction time and water/castor oil ratio were not statistically significant within the investigated ranges, consistent with the range analysis.
As shown in Table 4 , regarding compressive strength, splitting tensile strength, flexural strength, and the comprehensive index, both the water-to-binder ratio and fiber content exhibited highly significant effects ( p < 0.01).
There were highly significant differences ( p < 0.01) only in the main effects (A, B).
Differences were considered statistically significant if the p values were * p < 0.05, and highly significant if the p values were, ** p < 0.01, *** p < 0.001, and **** p < 0.0001. 3.
Interestingly, 5 days later, they continued to increase until 9 days, displaying highly significant differences compared to culture plates ( p < 0.01).
Intra- and inter-individual differences were considered significant if p-values were less than 0.05 ( p < 0.05), and highly significant if p -values were less than 0.01 ( p < 0.01).
Statistical analysis of the concentrations of adsorbed compound at the different ratios evidenced for all compounds highly significant increases ( p ≤ 0.01) at each subsequent higher ratio tested, with the only exception for BPA at the ratios of 500 and 1000 ( Table 3 ).
A crucial finding is that all linear terms, as well as binary and ternary interaction terms (AB, AC, BC, ABC), are highly significant ( p < 0.01).
Values were considered significant if p < 0.05 (*) and highly significant at p < 0.01 (**), p < 0.001 (***), and p < 0.0001 (****). 3.
(3) Analysis of variance shows that the fiber dosage, length, and type all have highly significant effects on interlayer strength ( p < 0.01).