Excerpts

As the composition of AIN/CP changed, the friction coefficient of the TSG showed an increasing trend.

The creep rate showed a decreasing trend at a constant peak load of 100 mN.

A positive trend observed in the national materials economy over recent years is the greater importance of secondary raw materials and recycled materials.

The domestic consumption of raw materials reveals an increasing trend, whose dynamics vary depending on the material group.

The aging steps had a highly significant effect (η P 2 = 0.579) on the flexural strength of the material for all curing groups.

In addition, the fracture toughness exhibits an increasing trend as the volume fraction of equiaxial α phases decreases.

There has been an increasing trend in the usage of industrial as well as agricultural waste products as dispersed phase.

Our study showed that there may be significant differences not only in LMP sensitivity along the crystal’s axis but also on the surface of the slice.

When the tube filler stiffness becomes greater than a certain critical value (i.e., when p exceeds the critical value), as E increases, σ l U exhibits a decreasing trend.

An interesting trend was found for chemical immobilization, since the electrophoretic mobility of the modified samples was reduced for longer spacer molecules chains.

It is clear that there is an increasing trend in the number of research articles covering this topic, which indicates the importance of this topic for the academy and industry.

The adsorption efficiency shows a decreasing trend with the initial concentration of the Cu (II) ions from 100 to 700 mg/L.

Lower PEO concentrations resulted in lower densities of fibres, and there was a clear trend showing an increase in fibres density in samples prepared with 2, 3, and 4 wt%, with the latter producing the maximum densities observed.

The adhesion of the coatings ( Table 2 ) shows an increasing trend from about 88 N (Ic = 50 A) to about 97 N (Ic = 100 A).

The gas capture efficiency showed a decreasing trend, burdened with a non-systematic component, and ranged from 0.85% (cycle 1) to 0.72% (cycle 10).

A clear trend of increased micro-hardness was revealed by the indentations and an optimisation window for bonding parameters was identified.

Moreover, the thermal effect of each of them is quite significant.

Different samples showed a trend of an increasing proportion of small pores and a relatively decreasing ratio of large pores.

[ 27 ] found an almost insignificant effect of high water pressure (10 MPa) on concrete strength.

According to the above research results, with the increase of graphene volume content, the average energy release rate of materials showed a trend of increasing at first and then decreasing.

After PPA is incorporated, the softening point presents an increasing trend that rise dramatically when the PPA concentration exceeds 1.0 wt%.

As can be seen, G′ and G′′ exhibit a decreasing trend with increasing temperatures.

A p < 0.05 was considered significant, and a p < 0.01 was considered highly significant. 3.

Conversely, in the case of single-term Prony series, the R 2 coefficient exhibited a decreasing trend for the higher indentation rates.

However, there is also a clear trend.