Excerpts

Moreover, the simulated curve for the curing period of 28 days was more consistent with the measured values than that for 7 days, while the model fitting accuracy for 90 days achieved the best accuracy among the three groups, which indicated that the simulation accuracy of the model presented an increasing trend with the increase in the curing period. 4.

The review concluded that implant survival rate increases in a positive trend when the initial bone height increases from approximately 1 to 5 mm.

The dimensional change in the rolled 2024Al along the rolling direction generally shows a decreasing trend in the process of 190 °C constant temperature aging.

However, after ten days of storage, results indicated highly significant differences between all treatments.

With the increase in the polycondensation reaction temperature, the C-N bond absorption intensity showed a trend of increasing and then decreasing.

During the friction process, the value of circularity of the transfer film ( Figure 11 f) gradually increased, indicating that the boundary profile of the transfer film approaches a circle more closely; however, the rectangularity of the transfer film ( Figure 11 g) did not exhibit a significant trend.

However, with the addition of GNSs, the tensile strength and elongation show a decreasing trend.

The observation of the crack localization effect in cracked beams—resulting from the nonlinear interaction of longitudinal vibration and ultrasound—is quite significant.

From this figure, it can be seen that the overall tensile strength showed an increasing trend with the increase in Ni content.

The deflection measured at the centre of the specimen followed an increasing trend with respect to an increase in S/t.

It shows a decreasing trend after about 1350 °C, but the difference was less noticeable.

Both the residual stress and strain exhibited a decreasing trend with increasing initial deviatoric stress.

The elastic modulus demonstrated a notable trend of initially increasing and then decreasing with the increase in initial deviatoric stress under unloading confining pressure conditions. 4.3.

The peak strain and elastic modulus initially demonstrated an increasing trend, followed by a subsequent decline, with an increase in initial deviatoric stress.

For example, depending on the condition of its surface, differences in the emissivity for steel may be significant, as demonstrated in Table 1 .

Nevertheless, the mean free path of transition metal borides demonstrates an increasing trend with the energy increment up to approximately 4 MeV.

With regard to the reinforced AZ91, both the tensile strain at fracture and the strain at maximum stress show an increasing trend similar to the nonlinear function as a function of tensile testing temperature.

The study revealed a clear trend in the dielectric constant of the membranes: PEI containing hydrophilic MSPs > PEI > PEI containing hydrophobic MSPs.

Moreover, analyzing the axial shrinkage recorded for clay compositions PV1–PV4 (compositions that do not contain dextrin), a decreasing trend of this indicator is observed as the amount of lime increases.

With respect to the amount of porosity left in the sintered alloys, an increasing trend is found.

As the molar ratio of F to Ti content in the precursor solution increased from 0.1 to 0.3, the sensor’s response to 10 ppm formaldehyde exhibited an increasing trend.

In some cases, there may be significant bone loss around the knee.

With the increase of Cl − concentration, the corrosion rate shows a trend of increasing and then decreasing, which in Cl − concentration less than 10,000 mg/L, with the increase of Cl − concentration, the corrosion rate increases, while in Cl − concentration higher than 10,000 mg/L, the corrosion rate shows a decreasing trend; this is because with the increase of Cl − concentration, O content will be reduced, thus hindering the corrosion process.

There is a clear trend that the thickness of the TiO 2 thin films decreased from 140 nm to about 80 nm with an increasing annealing temperature from 400 °C to 600 °C.

The overall change in stress indicates an increasing trend at first, followed by a gradual decrease.