Despite the fact that the relative density follows a decreasing trend with the increase of the ammonia flow time, it should be noted that hardness follows a growing tendency.
Excerpts
a clear trendgold
As the curing progressed, mixture B-0-N showed a clear trend of more Al uptake in the C-S-Hs with the increasing Si/Ca ratio.
It can be seen from Figure 6 a that the storage modulus of sample D-4 increased at first and then decreased, while other samples showed an increasing trend with loading.
In Case II, an increasing trend can be observed.
It is also worth noting that, at a low frequency band, i.e., 3–9 GHz, a decreasing trend can apparently be found for the real part of the permittivity.
Even at a Reynolds number much lower than 1, this efficiency remains quite significant (≈0.3) while the theoretical behavior in Stokes flow is particles avoiding each other at their initial relative positions, which leads to zero efficiency.
Since immunotherapies are becoming an important trend to treat non-communicable diseases, the RAGEp/PSiP vaccine will serve as a useful model in the development of chronic conditions such as Alzheimer’s disease and cancer.
Once NPs, PVDF and DBP were blended, the ε c was found to show a decreasing trend with increasing the testing frequency.
It is interesting to note that the O-Ce bond length initially showed an increasing trend, which became nearly constant for CeZr-2, CeZr-3, CeZr-4, and CeZr-6. 3.2.
Moreover, the B / G ratios for the Al–Li–Sc system decrease with the increase of Sc concentration (from 0 to 12.5%), while an increasing trend of B / G ratios is found in the Al–Li–X (X = Co, Zn, and Mo) systems.
Therefore, to comprehensively understand the corrosion mechanism and to predict the corrosion of steel in the oxygen-containing aqueous solution are highly significant.
Similarly, YS exhibits a decreasing trend along 45° and TD.
a possible trendgold
Finally, an analysis of the features extracted from the time and frequency was carried out to identify a possible trend and a correlation with the surface roughness. 3.
This behaviour is confirmed by the measurements of the hole diameters, which always show a decreasing trend of the measured values for 60 consecutive holes made with the same parameters and tools, as shown in Figure 10 .
In contrast, an increasing trend have been followed in the straightness deviations as a function of frequency, as can be seen in Figure 6 a.
In general, an increasing trend can be seen when wall thickness is increased, as seen in Figure 6 .
It is clear from Figure 6 a that E 1 of asphalt mortars presents a decreasing trend when the proportion of river sand ( X 3 ) increases, whereas the proportions of basalt ( X 1 ) and andesite ( X 2 ) have opposite effects on E 1 .
The mean size of γ grains and the amount of γ precipitation from B2 grains increased significantly with increased temperature, whereas B2 grains showed a decreasing trend.
With increasing welding energy, the indentation depth in both sides exhibited an increasing trend, as shown in Figure 3 , and the insert image shows the three-dimensional morphology of the surface indentation.
Up to 15% pre-strain, the peak transmittance shows a decreasing trend with increasing pre-strain because more and deeper wrinkles are formed as the pre-strain increases.
An increasing trend of cross-link density was subsequently reflected in improvement of modulus M100 and hardness of composites with increasing amount of co-agents ( Figure 3 and Figure 4 ).
The tensile strength of both type composites first slightly increased when the amount of peroxide increased up to 2 phr, then a decreasing trend of tensile strength was recorded with increasing content of peroxide ( Figure 16 ).
The current density has an increasing trend as the applied anodic voltage increases.
Using the voltage and the hot and cold side temperatures to calculate instantaneous value of Seebeck coefficient reveals an interesting trend of the Seebeck coefficient for both transient and steady state conditions.
The yield stress and viscosity of neat OWC slurries had a decreasing trend with the increase of WCRs.