Excerpts

As reported in Table 1 , roughness values are in the range of hundreds of nm, with an increasing trend with increasing anodizing time for both 200 V and 250 V limiting potential.

The σ F increased with an increase in RS p up to RS p V F : 0.45, and thereafter, a decreasing trend was observed.

In addition, a low amount of mica minerals of muscovite and biotite group and almost insignificant amount of clinochlore were found.

Highly significant safety aspects include the hazards of battery vent gas (BVG) or smoke and difficulties involved in firefighting, which is caused by failures of on-board large-capacity batteries.

Thermal Plasma Reduction of Minerals toward Nanoparticles of Oxide Recently, there has been an increasing trend toward the preparation of nanoparticles by using thermal plasma technology.

A clear trend was visible with the evolution of the M/S ratio.

In the case of k 2 and h coefficient values, there was an increasing trend of these parameters in the following series: La(III) > Pr(III) > Nd(III) > Ce(III).

Upon adding both reinforcements to Al matrix to form a hybrid nanocomposite, an interesting trend was observed.

Figure 2 a–d highlights a significant trend.

The averaged diameter size examined with a help of ImageJ software shows a decreasing trend with increasing homogenization time.

There is an increasing trend of using metal-free materials in the oral environment in order to avoid ion release and corrosion problems.

With the increase in the leaching time, the pH value showed a decreasing trend.

(2) When the average grain size is the same, as the size factor decreases, the error shows an increasing trend.

Looking at the phasegrams sequence, starting with the Neat sample, a clear trend between particle percentage and amounts of aggregates was found.

The kinetic correlation coefficient R 2 of the double temperature range was above 0.99, indicating that the regression effects are highly significant and credible.

With increasing hydration time, the compressive strength of the specimens shows an increasing trend.

With the increase of sintering temperature and sintering time, the microhardness of the specimens showed an increasing trend.

The chloride concentration in sea-exposed samples after 6 months exposure did not show an obvious trend as a function of the depth.

The comparison of the probing pocket depth mean values (mean PPD) of M2′s distal aspect (distolingual, middistal, distobuccal) at times T1, T90 and T180 showed a positive trend in all parameters, recorded both at the experimental and the control sites ( Table 1 ).

Neither PDeF nor rGO significantly affects the bands at 869 and 755 cm −1 , relative to PLA’s amorphous and crystalline regions, respectively, as neither the position nor the intensity of these bands shows a clear trend with the sample composition.

Studying concrete permeability is therefore hugely significant because it is closely connected to the penetration of water, which reduces the pH value of the pore fluid and carries harmful ions, resulting in degradation and loss of mechanical strength.

Firstly, there is a strong trend of increasing conductivity with the increase of density; secondly, at a similar density the samples of pure copper have higher conductivity than composites (except [ 9 ]).

Similarly as for u ( P ) avg , likewise u ( P max ) increases absolutely but shows a decreasing trend of relative values with increasing temperature difference over the TEM.

Our results show an increasing trend of the electron-phonon coupling factor for high electron temperature.

It can be found that with the extension of the fire time, the horizontal bearing capacity of the SRCFST columns displayed a decreasing trend, and the stiffness of the elastic phase also decreased where the heating period was 60 min, 90 min, and 120 min, respectively.