“a statistical trend”

When a cut-off of BED2 = 78 Gy was used, the higher BED2 values resulted in improved local control with a statistical trend to significance (p = 0.0999).

Consequently, a statistical trend ( P < 0.10) toward reduced levels of lipid and protein oxidation products was observed after 45 days of frozen storage (Fig. 1(b),(c) ).

A statistical trend was defined as 0.05 > p -value < 0.1.

When a statistical trend ( P < 0.1) was evident with at least one of the between-group differences with glimepiride, within-group changes from baseline to final measures were compared with dependent Student t tests or the Wilcoxon matched-pairs test as appropriate.

However, in both protocols a statistical trend ( p < 0.10) for improved live birth rate per started cycle was observed for HP-hMG compared with rFSH ( Figure 1B ).

Statistical significance was assessed at the 95 % confidence level (α=0.05) using Snedecor's F as the contrast statistic, while differences were considered a statistical trend when 0.05 < P < 0.10.

Statistical significance is displayed as ∗ p < 0.05, ∗∗ p < 0.01 and ∗∗∗ p < 0.001 whilst a statistical trend of p < 0.1 and >0.05 is displayed as a number.

Statistical significance was defined as p<0.05, and a statistical trend was defined as p<0.1.

For the first model, DCM connectivity parameters showing a significant ( P < 0.05) Pearson correlation or a statistical trend ( P < 0.1) were defined as a block of independent variables.

A statistical trend was defined for significance levels up to p = 0.1.

Following descriptions of statistical significance refer to a p-value<0.05, and a statistical trend is considered to indicate a p-value<0.1.

There was a statistical trend favoring ATEs in patients with “extensive disease” (OR 5.3. p = 0.10) or elevated LDH (OR 3.4, p = 0.10), while no association was found with chemotherapy protocol (especially cisplatin vs. carboplatin, OR 2.12, p = 0.69), histology, or high blood pressure.

There was a statistical trend for group differences at T2 (end of intervention; t = 1.7; p < .10).

They found a statistical trend towards a higher number of events in the ≥50% dose relative to the <50 dose group (54.2% vs. 50.8%, P = 0.10). 22 In a similar line, we found a poorer outcome among those CCS patients on the higher beta-blocker dose relative to dose not on beta-blocker.

Examination of the second pre-performance condition showed a statistical trend ( p = 0.1) for a positive association between LFms 2 activity and flow.

For these transfers, the comparisons are significantly different except for the comparison to the coevolved pathogens from transfer 20 exposed to the ancestral host, which still indicated a statistical trend ( p < 0.1; S1 Table ).

A statistical trend was considered for 0.05 ≤ P < 0.10.

Statistical significance was defined as P < 0.05, while a statistical trend was defined as 0.05 ≤ P < 0.10.

To account for baseline imbalances in relevant clinical parameters showing a statistical trend ( P < 0.1) in prior univariate analysis between EEN and nEEN cohorts, we performed a propensity score (PS) matching (balanced, parallel nearest-neighbor approach, ratio 1:many, caliper 0.2) ( 11 ).

The positivity of NF-kB (p65) was associated with shorter survival of 9.9 months versus 13 months in patients with negative expression of the same receptor, with only a statistical trend of P = 0.1 (see Table 1 ).

Three out of 10 mice injected with HCT116‐∆Np73 presented lung metastasis versus none of the control mice, showing a statistical trend ( P = 0.1; by the Fisher's exact test).

The multivariable models were restricted to the primary independent variable (aspirin initiation timing) and covariates demonstrating either a statistical trend ( P < .10) or established clinical relevance.

There was a statistical trend (post hoc p = 0.1) toward male BALB/cJ mice having higher corticosterone levels compared to female BALB/cJ mice (independent of stress condition, 204.3 ng/mL ± 170.9, 127.6 ng/mL ± 114.3, respectively).

A statistical trend was considered for P < 0.10.

Variables reaching a statistical trend in univariable analysis (P<0.1) were included in the final model.